fan clutch removal tool

 In Uncategorized

A fan clutch is featured on rear wheel drive cars only because it connects to the water pump and faces the radiator while pulling air through the radiator’s cooling fins when the engine is operating. The fan clutch freewheels while the engine is cold and then starts to work when the engine gets hot and requires the aid of the fan to keep the engine from overheating.

What goes wrong?

As with all automotive parts they can go bad due to heat, usage and engine vibration. When a fan clutch goes bad it can do so by permanently freewheeling allowing the engine to overheat or it can lockup causing a loud roaring sound and decreased engine power output.

LET’S GET STARTED

1. Identify the Nut Size

Each fan clutch will have its own mounting nut size which will range from 22mm to 36mm depending on the application and manufacturer. You can also use a large adjustable wrench if you do not have the proper tool. You may need to remove the fan shroud to get at the cooling fan.

2. Hold the Water Pump Pulley

You must hold the water pump pulley in order to remove the fan clutch from the water pump. They make a special tool for this which you can get from Amazon for about $20.00 bucks or you can rent one for free from your local auto parts store. We loaned out our tool for this job and are waiting for its return so in the meantime we have this large pipe wrench which we were able to sneak onto the pulley to hold it for removal.

3. Remove the Fan Clutch

Next we installed a large crescent wrench onto the fan clutch nut. Then we hit it with a hammer to loosen the fan. If you are ever wondering which way to loosen the fan nut (some are reverse thread) it will always loosen in the same direction as the fan turns when the engine is running. Once the fan is loose simply keep rotating the fan in the same direction while watching the threads to make sure the fan clutch in turning without the nut. If the nut is not turning use the wrench to help it along. Use your opposite hand to support the fan blade so it does not hit the radiator and cause a leak when the fan becomes loose. That would take the fun out of the job. The image below shows the two handed removal method.

4. Replace the Fan Clutch

There will be four to six 10mm bolts that will hold the actual clutch part of the fan to the fan blade itself. Remove these nuts and the clutch will come free from the blade. Once you have matched up the old fan clutch to the new unit reassemble it by installing and tightening the nuts in a cross pattern.

5. Reinstall the Fan Clutch

Once the new part has been installed gently slip the fan clutch down in front of the water pump using caution as to not contact the radiator or damage the plastic fan blade.

Conclusion

These are the process you can follow to establish a successful fan clutch removal process.

Recent Posts

Leave a Comment